Winnebago Wcp37Rq (1986) – 87V156000
Vehicle recall defect – Certain Components Were Incorrectly Assembled; Such As The Heat Resistant Cover On The Wiring Harness, Located Above The Exhaust System And The Mufflers Rear Heat Shield And Rear Hanger.
Vehicle recall defect – Certain Components Were Incorrectly Assembled; Such As The Heat Resistant Cover On The Wiring Harness, Located Above The Exhaust System And The Mufflers Rear Heat Shield And Rear Hanger.
Vehicle recall defect – The Brass Fitting On One End Of The Low Pressure Lp Gas Hose Could Be Inadequately Crimped To The Hose Allowing Gas To Leak. Consequence Of Defect: A Leak Could Develop In The Lp Gas System With Potential For Explosion And/Or Fire. Note: Owners Should Shut Off The Lp Supply At The Tank And Not Use The Lp System Until The CorreCTIve Action Has Been Completed.
Vehicle recall defect – The Mating Surface On Some Laminated “J” Hooks May Be Uneven, Or The Swing Down Arms Unequal In Length, Either Of Which Could Result In Uneven Load Bearing Of The Hooks.
Vehicle recall defect – Heavy Load And/Or Highly Compressed Rear Suspension Could Cause The Rear Brake Hose To Contact The Passenger’S Right Footpeg Securing Stud, Possibly Fraying The Hose. Consequence Of Defect: The Hydraulic Brake Hose Could Wear Through, Causing A Leak And Resulting In The Failure Of The Rear Brake System. Failure Of The Rear Brake System May Contribute To An Accident And Personal Injury.
Vehicle recall defect – The Distance Between The Fuel Cock And Carburetor May Be Insufficient To Allow Proper Clearance For The Outlet Fuel Line Causing It To Chafe. Consequence Of Defect: Continued Chafing Could Cause The Fuel Line To Fail, Allowing Gasoline To Leak Which May Result In A Fire If A Source Of Ignition Is Present.
Vehicle recall defect – Front Hydraulic Brake Fluid Hose May Contact Speedometer Cable During Normal Vertical Movement Of The Front Suspension.
Vehicle recall defect – Positive Battery Cable Lead To The Starter Solenoid May Separate From The Routing Clamp Cutting The Insulation On The Lead.
Vehicle recall defect – Front Wheel Bearing Could Fail Due To Lack Of Lubrication.
Vehicle recall defect – The Front Seat Belt Retractors, The Center Common Seat Belt Mount And The Rear Inboard Seat Belt Anchors Were Improperly Installed. Consequence Of Defect: Improperly Installed Seat Belt Anchors And Attachments Could Result In Passengers Not Being Properly Restrained In Event Of An Accident. This Is In Violation Of Fmvss No. 210.