4300

Vehicle recall defect – Certain Trucks Equipped With Engine Starters (Code 08Wwn Or 08Wwp) Built By Leece-Neville. These Starters Have A DefeCTIve Terminal Adapter Stud. The StUD Is Used Only At The Positive Battery ConneCTIon To The Starter Solenoid. It Was Designed To Be Screwed On Over The Existing StUD To Increase The StUD Diameter To Accommodate The Larger Size Of The Positive Battery Cable Terminal. The Adapter StUD Was Weakened When The Hole Was Drilled Too Deep.

Vehicle recall defect – On Certain Heavy Duty Trucks Equipped With Iros Rear Air Suspensions, During Assembly, Four Bolts And Nuts Holding The Main Support Member Bushing Bar Pins To The Main Support Member Hangers Were Incorrectly Tightened.

Vehicle recall defect – Vehicle Description: Trucks. An Incorrect Grade 5 Flange-Nut Was Installed In Place Of A Grade 8 Nut And Flat Washer On The Yoke Pinch Bolt That Holds The ConneCTIon Between The Lower End Of The I-Shaft And The Steering Gear.

Vehicle recall defect – On Certain School And Transit Buses Built With Bosch Zero Offset Pin Slide (Zops) Hydraulic Disc Brakes, The Zops Hydraulic Disc Brakes May Experience Calipers Sticking In The Applied Position, Which Can Result In Excessive Or Abnormal Heat Generation At One Or More Of The Brakes.

Vehicle recall defect – Certain Trucks Fail To Comply With The Requirements Of Federal Motor Vehicle Safety Standard No. 120, “Tire SeleCTIon And Rims For Motor Vehicles Other Than Passenger Cars,” And With Part 567, ‘Certification.’ The “Complete Vehicle” Label With The Gross Vehicle Weight Rating (Gvwr), Gross Axle Weight Rating (Gawr), Recommended Tire Size And Tire Pressure Was Not Installed On The Vehicle.

Vehicle recall defect – On Certain School And Transit Buses Built With Bosch Zero Offset Pin Slide (Zops) Hydraulic Disc Brakes, The Zops Hydraulic Disc Brakes May Experience Calipers Sticking In The Applied Position, Which Can Result In Excessive Or Abnormal Heat Generation At One Or More Of The Brakes.

Vehicle recall defect – Certain Trucks Fail To Comply With The Requirements Of Federal Motor Vehicle Safety Standard No. 209, “Seat Belt Assemblies.” The Seat Belt Latch Failed A Quality Review.

Vehicle recall defect – On Certain School And Transit Buses Built With Bosch Zero Offset Pin Slide (Zops) Hydraulic Disc Brakes, The Zops Hydraulic Disc Brakes May Experience Calipers Sticking In The Applied Position, Which Can Result In Excessive Or Abnormal Heat Generation At One Or More Of The Brakes.

Vehicle recall defect – Certain Heavy Duty Trucks Fail To Comply With The Requirements Of Federal Motor Vehicle Safety Standard No. 121, “Air Brake Systems.” The Primary And Secondary Air Supply Hoses From The Foot Valve To The Primary And Secondary Air Tanks Were Improperly Routed At The Tank.

Vehicle recall defect – Certain School Buses And Heavy Duty Trucks Built With Hydraulic Brakes And An Air Powered Parking Brake (Brake Code 04Gas) Fail To Comply With The Requirements Of Federal Motor Vehicle Safety Standard No. 105, “Hydraulic And Electric Brake Systems.” The Hydraulic Brake Monitor Module Was Not Installed On Certain Vehicles.