Vehicle recall defect – On Certain Passenger Vehicles. If The Engine Fails To Start And The Driver Holds The Key In The “Start” Position For An Extended Period, High Current Flows Through The Ignition Switch, And Sometimes Produces Enough Heat To Melt Internal Switch Parts.
Vehicle recall defect – Vehicle Description: Passenger Vehicles. These Vehicles Were Built With The Potential For The Interior Lamps To Come On Unexpectedly While The Vehicles Are Being Driven. This Does Not Meet The Requirements Of Fmvss No. 101, “Controls And Displays.”
Vehicle recall defect – The Front And/Or Rear Hazard Warning Lamps (Four-Way Flashers) Do Not Flash When The Hazard Switch Is Activated. This Fails To Comply With Fmvss No. 108, “Lamps, RefleCTIve Devices, And Associated Equipment.”
Vehicle recall defect – During Deployment Of The Passenger Air Bag, The Air Bag Fabric Can Snag On A Reinforcement Inside The Instrument Panel, Causing The Expanding Air Bag To Lift The Instrument Panel Pad And Then Deploy Under The Instrument Panel Instead Of Through The Door In The Instrument Panel.
Vehicle recall defect – Certain Delphi Fuel Pressure Regulators, P/Nos. Fp10020-11B1, Fp10026-11B1, And Fp10027-11B1, Sold After January 9, 2007, As Aftermarket Equipment For Various Passenger Vehicles Listed Above. The Universal Pressure Regulators (Upr) Were Produced Without An O’Ring And Retainer.
Vehicle recall defect – Certain Delphi Aftermarket Fuel Pump Modules / Module Reservoir Assemblies (Mra) That Were Sold For Use On The Above Listed Vehicles. During ProduCTIon The Mras Vent And Fuel Return Tubes Were Reversed. This Condition Can Result In The Vehicle Not Running Correctly (Idle Rough And/Or Stall) Due To An Overly Rich Fuel Blend Or The Vehicle’S Evaporative Emission Carbon Canister May Leak Fuel.
Vehicle recall defect – On Certain Passenger Vehicles. If The Engine Fails To Start And The Driver Holds The Key In The “Start” Position For An Extended Period, High Current Flows Through The Ignition Switch, And Sometimes Produces Enough Heat To Melt Internal Switch Parts.
Vehicle recall defect – Vehicle Description: Passenger Vehicles. If The Engine Starter Fails To Engage And The Driver Hold The Key In The “Start” Position For An Extended Period, High Current Flows Through The Ignition Switch, Producing Heat That Can Melt Switch Parts.
Vehicle recall defect – These Vehicles Were Constructed With Welds In The Rear Compartment Pan Assembly That Are Not Sufficient To Comply With The Requirements Pertaining To Fuel Tank Leakage In The Event Of A Rear Impact Collision. The Fuel Tank Assemblies Do Not Comply With Fmvss No. 301, “Fuel System Integrity.”
Vehicle recall defect – Vehicle Description: Passenger Vehicles. If The Engine Starter Fails To Engage And The Driver Hold The Key In The “Start” Position For An Extended Period, High Current Flows Through The Ignition Switch, Producing Heat That Can Melt Switch Parts.