Fleetwood Bounder (1988) – 88V097000
Vehicle recall defect – Misrouted Battery Cables Could Come In Contact With Hot Oil Cooler Lines Or Sharp Objects And Damage The Insulation.
Vehicle recall defect – Misrouted Battery Cables Could Come In Contact With Hot Oil Cooler Lines Or Sharp Objects And Damage The Insulation.
Vehicle recall defect – The Steering Column Shaft Nut Retaining Clip May Be Missing. Under Certain Conditions, The Lack Of A Retaining Clip Will Allow The Nut To Work Loose And The Steering Wheel To Separate From The Steering Column.
Vehicle recall defect – Spare Tire Carrier May Fail In Service Allowing The Tire And Wheel Assembly To Drop Onto The Ground.
Vehicle recall defect – Misrouted Battery Cables Could Come In Contact With Hot Oil Cooler Lines Or Sharp Objects And Damage The Insulation.
Vehicle recall defect – Fuel Tanks May Crack In Service Due To Fatigue Of Material Around Weld.
Vehicle recall defect – Screws Holding Support Framing For Liquid Propane Gas (Lpg) Tank And Generator May Not Be Properly Installed And May Cause The Tank And/Or Generator To Fall Off The Motorhome While On The Highway. Consequence Of Defect: Without Proper Securing, The Lpg Tank And/Or Generator Could Shift And Fall Off While Motor Home Is Traveling On The Highway. This Could Cause A Highway Hazard And Cause The Operators Of Other Vehicles To Lose Control, Which May Possibly Result In A Vehicle Crash.
Vehicle recall defect – Fuel Tanks May Crack In Service Due To Fatigue Of Material Around Weld.
Vehicle recall defect – Vehicle Description: Class A Motor Homes. The Hydraulic Hoses Which Operate The Leveling Jack System Is Routed Too Close To The Engine Exhaust Manifold Causing The Hose To Melt, Releasing Hydraulic Fluid.
Vehicle recall defect – The Windshield Wiper System Hardware Was Incorrectly Mounted, Causing Wiper Blade Overtravel And Premature Wear, And In Extreme Cases, The Wiper Blades May Fail To Correctly Travel Over The Windshield.
Vehicle recall defect – The E-Z Slide-Out Room Can Operate Unexpectedly. Water Can Cause An Electrical Short In The Slide-Out Room Control Relay.