buell

Buell 1125R (2008) – 09V109000

Vehicle recall defect – Buell Distribution Company Is Recalling 3,316 My 2008 1125R, My 2009 Xb12R And Xb12Scg Motorcycles. The Subject Motorcycles Have A Front Brake Line Which May Contact The Front Tire. The Condition Could Cause A Hole To Develop In The Front Brake Line, Allowing Brake Fluid To Leak.


Buell 1125R (2008) – 08V267000

Vehicle recall defect – Buell Is Recalling 1,579 My 2008 1125R Motorcycles. These Vehicles Can Experience 5Th Gear Galling On The Clutch Shaft Due To Lack Of Lubrication. This Condition Can Allow The Gear To Seize To The Shaft, Resulting In Rear Wheel Lock-Up.


Buell 1125Cr (2009) – 08V554000

Vehicle recall defect – Buell Is Recalling 140 My 2009 1125Cr Motorcycles. These Motorcycles Can Experience A Premature Failure Of The Rear Cylinder Cam Chain Tension Guide (Part Number F0020.1Am). This Can Cause Plastic Debris To Block The Oil Pump Screen, Possibly Leading To Oil Starvation And Engine Seizure.


Buell 58214-06Ya – 06E061000

Vehicle recall defect – Certain Aftermarket Tall Windscreens Sold Exclusively For Use On 2006 My Buell Ulysses Model Motorcycles, P/N 58214-06Ya. The Retention Fasteners For The Subject Windscreens Can Fail Allowing The Windscreen To Become Dislodged While The Vehicle Is Being Driven At Highway Speeds.


Buell M2 Cyclone (1997) – 97V153000

Vehicle recall defect – Vehicle Description: Motorcycles. The E-Clip Which Retains The Drive Pin On The Front Brake Rotor And Carrier Can Separate From The Drive Pin Allowing The Pin To Move Out Of Position And Come In Contact With The Front Brake Caliper.


Buell M2 (2002) – 02V003000

Vehicle recall defect – Certain Motorcycles Were Built With A Front Shock Mount That Is Cracked And Could Break Allowing The Suspension To Drop Unexpectedly.


Buell M2 (1999) – 98V199000

Vehicle recall defect – Vehicle Description: Motorcycles. The Swing Arm On These Motorcycles Was Improperly Manufactured.


Buell M2 (1998) – 98V036000

Vehicle recall defect – Vehicle Description: Motorcycles. Failure Of One Or More Turn Signal Lamps Would Not Be Indicated To The Operator Of The Vehicle (No Noticeable Change In The Flashing Rate Of The Turn Signal Indicator Light). This Does Not Meet The Requirements Of Fmvss No. 108, “Lamps, RefleCTIve Devices, And Associated Equipment.”