ciera

Vehicle recall defect – These Vehicles Were Assembled With Rear Outboard Safety Belt Anchorages That May Not Withstand The Required Load. This Does Not Comply With Fmvss No.210, “Seat Belt Assembly Anchorages.”

Vehicle recall defect – The Power Seat Or Recliner Wiring Harness Can Be Pinched Or Can Chafe On The Seat Frame Or Spring Support Rod, Wearing Through The Wire Insulation And Causing An Electrical Short.

Vehicle recall defect – These Vehicles Were Assembled With Rear Outboard Safety Belt Anchorages That May Not Withstand The Required Load. This Does Not Comply With Fmvss No.210, “Seat Belt Assembly Anchorages.”

Vehicle recall defect – Fuel Feed Hose Could Leak At The Coupling On The Engine End Of The Hose Assembly.

Vehicle recall defect – Poor Bond Adhesion Between The Windshield Glass And Mounting Could Allow The Windshield To Separate During A 30 Mph Frontal Barrier Test Required By Fmvss 212.

Vehicle recall defect – The Fuel System May Leak At The Throttle Body InjeCTIon Fuel Feed Pipe ConneCTIon. Consequence Of Defect: This Leakage Could Result In An Underhood Fire Which Could Spread To The Passenger Compartment And Cause Burn Injuries To Occupants.

Vehicle recall defect – Some Vehicles Have Bucket Seat Back Locks That Do Not Conform To Federal Motor Vehicle Safety Standard 207, Anchorage Of Seats. In Event Of A Crash, The Seat Back Lock May Not FunCTIon.

Vehicle recall defect – The Brake Proportioner Valves May Break And Separate From The Master Cylinder. This Would Allow Brake Fluid To Leak And Would Result In A Partial Loss Of The Brake System.

Vehicle recall defect – In The Event Of A Primary Accelerator Control Spring Failure, The Secondary (Back-Up) Accelerator Control Return Spring Will Not Return The Throttle To The Fully Closed Position, As Required By Fmvss No. 124, “Accelerator Control System.”

Vehicle recall defect – These Vehicles Were Assembled With Rear Outboard Safety Belt Anchorages That May Not Withstand The Required Load. This Does Not Comply With Fmvss No.210, “Seat Belt Assembly Anchorages.”