Vehicle recall defect – Two Screws Which Secure The Shift Linkage Bracket May Loosen And Fall Out. Consequently, The Gear Position Indicated On The Transmission Selector May Differ From The Actual Gear Position Of The Transmission. This Constitutes A Non-Compliance To Federal Motor Vehicle Safety Standard No. 102, “Transmission Shift Lever Sequence, Starter Interlock, And Transmission Braking Effect”.
Vehicle recall defect – Vehicles Fail To Comply With Federal Motor Vehicle Safety Standard No. 105, “Hydraulic Brake Systems”. An Incorrect Parking Brake Adjusting Spring Was Installed On Certain Vehicles. This May Cause Interference When Attempting To Apply The Parking Brakes.
Vehicle recall defect – The Transmissions Have Been Assembled With A Higher Than Normal Return Spring Load On The Transmission Locking Pawl. When The Park Position Is Selected With The Transmission Shift Lever, The Parking Pawl May Not Engage.
Vehicle recall defect – The Fuel Filters Were Produced With An Incorrect Threaded Fitting. The Incorrect Fitting Is Similiar Enough In Size That The Fuel Filter May Appear To Be Correctly Threaded Onto The Fuel Line.
Vehicle recall defect – During Windshield Wiper Operation, The Noise Suppresion Capacitor In The Wiper Motor Relay May Overheat.
Vehicle recall defect – Threaded Inflator Components May Have Been Damaged During Assembly Which May Allow Components To Separate When Inflator Receives A Signal To Deploy The Air Bag.
Vehicle recall defect – The Fuel Filters Were Produced With An Incorrect Threaded Fitting. The Incorrect Fitting Is Similiar Enough In Size That The Fuel Filter May Appear To Be Correctly Threaded Onto The Fuel Line.
Vehicle recall defect – One Or Both Abs Hydraulic Unit Mounting Bolts May Not Be Properly Seated And Could Loosen.