Vehicle recall defect – On Certain Motor Homes, The Water Heater Exhaust On The Curve Side Wall Under The Back Side Of The Kitchen Slideout Room Box Terminates Under The Slide Box When In The Extended Position. This Design Could Create A Risk Of Migration Of Carbon Monoxide Into The Interior Of The Motor Home.
Vehicle recall defect – On Certain Motor Homes Manufactured With Optional Aqua Hot Hydronic Heaters, The Exhaust Termination For The Heater Was Located Under The Bedroom Slide Out, When It Should Have Been Placed Beyond The Periphery Of The Vehicle.
Vehicle recall defect – On Certain Motorhomes Equipped With Cummins Engines, Oil Can Leak Into The Engine Compartment From A Crack In The Cup Plug.
Vehicle recall defect – On Certain Class A Motor Homes Equipped With Vehicle Systems’ Aqua-Hot And Hydro-Hot Water Heaters, Which Use Webasto Burner Tubes, The Burner Tubes Do Not Meet Specifications And Could Fail Prematurely.
Vehicle recall defect – On Certain Motor Homes, The Water Heater Exhaust On The Curve Side Wall Under The Back Side Of The Kitchen Slideout Room Box Terminates Under The Slide Box When In The Extended Position. This Design Could Create A Risk Of Migration Of Carbon Monoxide Into The Interior Of The Motor Home.
Vehicle recall defect – On Certain Motorhomes Certification TAGS Were Omitted On The Cloth Covered Front And Rear Brake Line Assemblies.
Vehicle recall defect – On Certain Motor Homes, An Incorrect Screw Was Used To Install The Black And White Crt Back-Up Monitor In The Dash. The Incorrect Screws Are 1/4″ Longer Than Specified And May Contact A Pc Board Inside The Monitor Which Could Potentially Hit A High Voltage Circuit On The Pc Board Of Approximately 10,000-13,000 Volts.
Vehicle recall defect – On Certain Motor Homes Equipped With Atwood Sealed Burner Ranges, The Range And Slide-In Burner Tubes Leading From The Gas Manifold To The Burner Heads Had A Depression Or ‘Kink’ In The Exterior Bend RestriCTIng Proper Airflow And Gas Mixture.
Vehicle recall defect – Certain Motor Homes Fail To Conform To The Requirements Of Federal Motor Vehicle Safety Standard No. 121, ‘Air Brake Systems.’ Two Delivery Lines On The Brake System Were Installed Incorrectly.
Vehicle recall defect – On Certain Class A Motor Homes, The Spacer Plate Under The Trailing Arms Had A Transverse Weld Which Creates A Heat Riser And Cause The Trailing Arms To Crack.