Neoplan Adb (1984) – 88V001000
Vehicle recall defect – Additional Labeling Of Emergency Exit InstruCTIons Is Needed To Comply With Fmvss 217 Requirements.
Neoplan An116 (1999) – 01V033007
Vehicle recall defect – Vehicle Description: Transit Buses Equipped With Vanner 60 Series Battery Equalizers. The Equalizer Could Fail To Operate Properly And Cause MalfunCTIon Of The Battery Charging System.
Neoplan Adb (1983) – 88V001000
Vehicle recall defect – Additional Labeling Of Emergency Exit InstruCTIons Is Needed To Comply With Fmvss 217 Requirements.
Neoplan An116 (1998) – 98V308001
Vehicle recall defect – Vehicle Description: Transit Buses. The Tether Plates, Which Are Attached To The Rear Of Both The Upper And Lower Frames Of The Suspension Unit, Contain A Sharp Edge Which Can Cause Premature Weat Of The Nylon Tethers. This Does Not Comply With The Requirements Of Fmvss No. 207, “Seating Systems,” And No. 210, “Seat Belt Assembly Anchorages.”
Neoplan Adb (1982) – 88V001000
Vehicle recall defect – Additional Labeling Of Emergency Exit InstruCTIons Is Needed To Comply With Fmvss 217 Requirements.
Neoplan An116 (1998) – 01V033007
Vehicle recall defect – Vehicle Description: Transit Buses Equipped With Vanner 60 Series Battery Equalizers. The Equalizer Could Fail To Operate Properly And Cause MalfunCTIon Of The Battery Charging System.
Neoplan Adb (1981) – 88V001000
Vehicle recall defect – Additional Labeling Of Emergency Exit InstruCTIons Is Needed To Comply With Fmvss 217 Requirements.
Neoplan An116 (1996) – 96V178003
Vehicle recall defect – Vehicle Description: Buses Equipped With Isringhausen Seats In The Driver Position. Two Welds Located On The Back Rest Adjustment Side Of The Seat Frame Did Not Meet The Manufacturer’S Specifications.
Neoplan 340/3 Transit Bus (1987) – 91V115000
Vehicle recall defect – Leaking Hoses Caused Refrigerant Levels To Decrease Causing Excessive Cycling Of The Ac Clutch.
Neoplan An116 (1995) – 96V178003
Vehicle recall defect – Vehicle Description: Buses Equipped With Isringhausen Seats In The Driver Position. Two Welds Located On The Back Rest Adjustment Side Of The Seat Frame Did Not Meet The Manufacturer’S Specifications.