- Vehicles
- 2,193
- Built between
- Not published
- Models
- 1
- Recall type
- Vehicle
- Initiated by
- Manufacturer
- Owners notified
- 12 October 2012
- Repaired
- Not reported
- Unrepaired
- Not reported
Does this affect my vehicle?
The manufacturer did not publish a build-date range for this recall, so the model and year list below is the only way to tell whether your vehicle is covered.
- 2011-2012 Altec Digger Derrick
What the defect is
Altec Industries, Inc. is recalling certain model year 2011-2012 Digger Derrick vehicles equipped with a PENGO digger extension shaft. A defect in the base material at the weld joint may result in a stress fracture through the applied weld of the drive hub to the hex bar material.
What could happen
The stress fracture could cause the extension shaft to separate from the drive hub when digging, increasing the risk of personal injury and/or property damage.
What gets fixed
Altec will notify owners, and will inspect the PENGO digger extension shaft and, as necessary, replace the shaft, free of charge. The safety recall began on October 12, 2012.
Timeline
- Recall reported to NHTSA30 August 2012
- Owners notified12 October 2012
Your rights
A safety recall repair is free. Under US federal law the manufacturer must fix a safety defect at no cost to you — no charge for parts, labor or diagnosis — whether or not you are the original owner. A dealer cannot charge you for recall work, and cannot require you to have bought the vehicle from them.
That entitlement is not unlimited. It applies where the vehicle was first sold less than 15 years before the recall was announced — 5 years for tires. Past that a manufacturer may still do the repair free of charge, and many do, but they are no longer obliged to. This recall was reported on 30 August 2012.
To arrange the repair, contact any franchised dealer for the brand. If a dealer refuses the work or tries to charge for it, you can report that to NHTSA at nhtsa.gov/recalls or on 1-888-327-4236.
Manufacturer contact
Owners may contact Altec Industries at 1-877-462-5832.
Official source
- Manufacturer's recall number
- CSN 568
- Recalling manufacturer
- ALTEC INDUSTRIES INC.
- Recall initiated by
- MFR
Everything on this page — the models listed, the build dates and the repair figures — comes from the manufacturer's filing to NHTSA and describes the vehicle line as a whole, not any individual car. Only the manufacturer can confirm whether a specific vehicle is affected, and whether its recall work has already been carried out. Check yours by VIN and read the official notice at nhtsa.gov/recalls.
Additional notes
Altec's recall campaign number is CSN 568.Customers may contact the National Highway Traffic Safety Administration's Vehicle Safety Hotline at 1-888-327-4236 (TTY: 1-800-424-9153); or go to http://www.safercar.gov.
Check your own vehicle
This page describes the recall, not any one car. To see which recalls cover a specific vehicle, search by make, model and year.
A VIN lookup here identifies your vehicle and shows recalls issued for that make, model and year. It cannot tell you what is still open on your individual car - only the manufacturer knows that. Search by VIN instead, or check your VIN at nhtsa.gov for whether a recall is still open on your individual car.