- Vehicles
- 19
- Built between
- Aug 2017 – Nov 2017
- Models
- 1
- Recall type
- Equipment
- Initiated by
- Manufacturer
- Owners notified
- 20 December 2017
- Repaired
- 58%
- Unrepaired
- 8
Does this affect my vehicle?
This recall covers vehicles built between August 2017 and November 2017. If yours was built outside that window, it is not part of this recall.
- IMT Dominator I Crane BodyBuilt August 2017 to November 2017
Repair progress
8 of 19 vehicles in this recall had still not been repaired as of Q1 2019.
58% repaired — 11 of 19 reported
Manufacturers file these figures with NHTSA each quarter. Vehicles the manufacturer could not trace, or that have been scrapped or exported, are counted separately and are not included in the unrepaired figure.
What the defect is
Iowa Mold Tooling Co., Inc. (IMT) is recalling certain Dominator I Crane bodies sold for installation onto other chassis. These cranes have incorrect stabilizer arm locking pins that may not engage properly allowing the stabilizer arm to extend from the side of the vehicle while traveling.
What could happen
If the locking arm pin does not engage, the stabilizer arm may extend while the vehicle is in motion, increasing the risk of a crash.
What gets fixed
IMT will notify owners, and dealers will replace the incorrect pin with a correct length pin, free of charge. The recall began on December 20, 2017.
Timeline
- Vehicles builtAugust 2017 to November 2017
- Recall reported to NHTSA13 November 2017
- Owners notified20 December 2017
- Latest repair reportQ1 2019 — 58% repaired
Your rights
A safety recall repair is free. Under US federal law the manufacturer must fix a safety defect at no cost to you — no charge for parts, labor or diagnosis — whether or not you are the original owner. A dealer cannot charge you for recall work, and cannot require you to have bought the vehicle from them.
That entitlement is not unlimited. It applies where the vehicle was first sold less than 15 years before the recall was announced — 5 years for tires. Past that a manufacturer may still do the repair free of charge, and many do, but they are no longer obliged to. This recall was reported on 13 November 2017.
To arrange the repair, contact any franchised dealer for the brand. If a dealer refuses the work or tries to charge for it, you can report that to NHTSA at nhtsa.gov/recalls or on 1-888-327-4236.
Manufacturer contact
Owners may contact IMT customer service at 1-800-247-5958. IMT's number for this recall is TB2017008.
Official source
- Manufacturer's recall number
- TB2017008
- Recalling manufacturer
- Iowa Mold Tooling Co., Inc.
- Recall initiated by
- MFR
Everything on this page — the models listed, the build dates and the repair figures — comes from the manufacturer's filing to NHTSA and describes the vehicle line as a whole, not any individual car. Only the manufacturer can confirm whether a specific vehicle is affected, and whether its recall work has already been carried out. Check yours by VIN and read the official notice at nhtsa.gov/recalls.
Additional notes
Owners may also contact the National Highway Traffic Safety Administration Vehicle Safety Hotline at 1-888-327-4236 (TTY 1-800-424-9153), or go to www.safercar.gov.
Check your own vehicle
This page describes the recall, not any one car. To see which recalls cover a specific vehicle, search by make, model and year.
A VIN lookup here identifies your vehicle and shows recalls issued for that make, model and year. It cannot tell you what is still open on your individual car - only the manufacturer knows that. Search by VIN instead, or check your VIN at nhtsa.gov for whether a recall is still open on your individual car.