Vehicle recall defect – Winnebago Is Recalling Certain Recreational Vehicles Equipped With 1200-Series Norcold Refrigerators. The Population Of Refrigerators Being Addressed Contains Either A Sensing Algorithm Or Thermal Switch To Shut Off Power To The Refrigerator When High Temperatures Are Detected In Order To Prevent A Potential Fire. The Response Times Of The Sensor Algorithm And Thermal Switch Devices To Stop Power Are Not Sufficient.
Vehicle recall defect – The Generator Fuel Supply Hose Located Adjacent To The Generator Was Not Routed Or Clamped Properly And Could Come In Contact With The Engine Exhaust.
Vehicle recall defect – The Liquid Propane (Lp) Gas Supply Hose Located Adjacent To The Lp Tank Can Contact The Tank Plumbing Guard Causing The Hose To Wear Through Allowing Lp Gas To Be Released.
Vehicle recall defect – The Certification Label On These Vehicles Contain Incorrect Tire Pressure Data. This Does Not Conform To The Requirements Of Federal Motor Vehicle Safety Standard No. 120, “Tire SeleCTIon And Rims For Motor Vehicles Other Than Passenger Cars.”
Vehicle recall defect – The “O” Rings Of The Regulator Assembly In The Onan Emerald And Marquis Brand Generator Sets Can Weaken And Break When Exposed To High Ambient Temperatures.
Vehicle recall defect – The Bolts Holding The Rear Wheel Brake Backing Plate To The Axle Were Not Torqued To Correct Specifications And Can Loosen.
Vehicle recall defect – The Bolts Holding The Rear Wheel Brake Backing Plate To The Axle Were Not Torqued To Correct Specifications And Can Loosen.
Vehicle recall defect – The “O” Rings Of The Regulator Assembly In The Onan Emerald And Marquis Brand Generator Sets Can Weaken And Break When Exposed To High Ambient Temperatures.
Vehicle recall defect – The Seat Belt “D” Ring Support Bracket For The Two Companion Seats (Seats Behind The Driver/Front Passenger Seats) Was Incorrectly Installed.
Vehicle recall defect – Vehicle Description: Transit Buses Equipped With Spicer 6,000 Or 8,000 Lb. Front Steer Axles. The Tie Rod End Can Pull Outboard And Separate From The Tie Rod Tube Due To Improper Thread Engagement Between The Male Tie Rod End And The Female Tube.