Vehicle recall defect – The Brakes Are Operated With VacuUM Assistance. The VacuUM Reservoir Tank May Develop Air Leaks From Rust Deterioration. The Rust Occurs Because The Position Of The Tank Does Not Allow Proper Drainage.
Vehicle recall defect – The L.P. Gas Bottle Hold-Down Assembly May Have Been Incorrectly Installed On The Involved Vehicles. As A Result, The L.P. Gas Bottles May Shake Loose From The Assembly And Fall From The Trailer Frame.
Vehicle recall defect – The Refrigerator Service Compartment Door May Not Be Of Sufficient Size To Provide Adequate Ventilation For Liquid Propane Gas In The Event Of A Leak In The Compartment. This Gas Is Heavier Than Air And Tends To Pocket Below The Level Of The Louvers, Thus Necessitating An Additional Vent Opening In The Floor Of The Compartment To Drain Off Any Accumulated Gas Pockets.
Vehicle recall defect – Under Severe Use, The “High Hysteresis” Rear Rubber Coupling Of The Drive Shaft May Develop Fatigue Resulting In Transmission Vibrations.
Vehicle recall defect – The Fuel Pump May Have Been Improperly Installed, Possibly Resulting In Misalignment Of The Pump.
Vehicle recall defect – Due To Installation Difficulties During Modification Of The Fuel Pump, The Pump May Have Been Misaligned. Certain Adverse Conditions Or High Loads Such As Trailer Towing, Motor Sports Events, Or Other Driving Modes Which Impose Abnormally High Loads On The Vehicles, Combined With Low Levels Of Fuel In The Tank, May Cause Lack Of Vehicle Power And Stalling.
Vehicle recall defect – If Vehicle Is Inadvertently Driven With The Parking Brakes Engaged, Severe Overheating Of The Cast Iron Brake DrUM May Occur.
Vehicle recall defect – On The Involved Vehicles, The Lateral Radius Rod Could Prematurely Fail, Allowing The Rear Axle To Shift Laterally While The Wheels Are Turning Or When The Vehicle Is Operated Over Severe Bumps Or Pot Holes. Failure Could Occur Due To A Part Number Stamp That Was Added In The Area Of The Bend On The Rod.
Vehicle recall defect – Information Supplied On The Certification Plate Is Insufficient And InAccurate.
Vehicle recall defect – The Involved Vehicles Are In Non-Compliance To Federal Motor Vehicle Safety Standard No. 108, “Lamps, RefleCTIve Devices, And Associated Equipment”, Due To Omission Of Rear Reflex Reflectors.