- Vehicles
- 563
- Built between
- Not published
- Models
- 1
- Recall type
- Vehicle
- Initiated by
- Manufacturer
- Owners notified
- 13 September 2011
- Repaired
- Not reported
- Unrepaired
- Not reported
Does this affect my vehicle?
The manufacturer did not publish a build-date range for this recall, so the model and year list below is the only way to tell whether your vehicle is covered.
- 2010-2011 Gillig LOW Floor
What the defect is
Gillig is recalling certain model year 2010-2011 lowfloor buses equipped with cummins engines. The v-band clamp assembly used to connect the inlet and outlet cone sections to the diesel oxidation catalyst (doc) diesel particulate filter (DPF) include a t-bolt which can fracture and fail when subjected to stress or load. A fracture or failure of the t-bolt may cause the clamp to loosen and the inlet or outlet sections attached to the doc/dpf housing to disconnect.
What could happen
If the inlet or outlet sections disconnect, hot exhaust gases can vent prior to exiting the tailpipe, creating the risk of combustion and a fire. If both clamps fail, there is a risk in some applications that the doc/dpf housing may detach completely, creating a road hazard.
What gets fixed
GILLIG IS WORKING WITH CUMMINS TO IDENTIFY OWNERS. CUMMINS IS HANDLING THE OWNER NOTIFICATION AND REMEDY FOR THIS CAMPAIGN PLEASE SEE NHTSA RECALL 11E-031.
Timeline
- Recall reported to NHTSA10 August 2011
- Owners notified13 September 2011
Your rights
A safety recall repair is free. Under US federal law the manufacturer must fix a safety defect at no cost to you — no charge for parts, labor or diagnosis — whether or not you are the original owner. A dealer cannot charge you for recall work, and cannot require you to have bought the vehicle from them.
That entitlement is not unlimited. It applies where the vehicle was first sold less than 15 years before the recall was announced — 5 years for tires. Past that a manufacturer may still do the repair free of charge, and many do, but they are no longer obliged to. This recall was reported on 10 August 2011.
To arrange the repair, contact any franchised dealer for the brand. If a dealer refuses the work or tries to charge for it, you can report that to NHTSA at nhtsa.gov/recalls or on 1-888-327-4236.
Manufacturer contact
Owners may contact cummins at 1-812-377-5000.
Official source
- Recalling manufacturer
- GILLIG CORPORATION
- Recall initiated by
- MFR
Everything on this page — the models listed, the build dates and the repair figures — comes from the manufacturer's filing to NHTSA and describes the vehicle line as a whole, not any individual car. Only the manufacturer can confirm whether a specific vehicle is affected, and whether its recall work has already been carried out. Check yours by VIN and read the official notice at nhtsa.gov/recalls.
Additional notes
Owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .
Check your own vehicle
This page describes the recall, not any one car. To see which recalls cover a specific vehicle, search by make, model and year.
A VIN lookup here identifies your vehicle and shows recalls issued for that make, model and year. It cannot tell you what is still open on your individual car - only the manufacturer knows that. Search by VIN instead, or check your VIN at nhtsa.gov for whether a recall is still open on your individual car.