Butler Suspension: Hanger/Bracket

Butler is recalling about 79 vehicles over a problem with the suspension.

Campaign
78V102000
Manufacturer
BUTLER MANUFACTURING
Reported
3 May 1978
Vehicles
79
Built between
Not published
Models
1
Recall type
Vehicle
Initiated by
Manufacturer
Owners notified
Not yet
Repaired
Not reported
Unrepaired
Not reported

Does this affect my vehicle?

The manufacturer did not publish a build-date range for this recall, so the model and year list below is the only way to tell whether your vehicle is covered.

  • 1976 Butler Butler

What the defect is

The welds joining the spring hangers to sub-frames may fail due to developing cracks which could cause the spring hanger to become loose.

What gets fixed

THE DEALER WILL INSPECT AND REPAIR ANY WELDS FOUND CONTAINING CRACKS.

Timeline

  1. Recall reported to NHTSA3 May 1978

No owner-notification date has been published yet. Manufacturers normally write to registered owners within 60 days of reporting a recall.

Your rights

A safety recall repair is free. Under US federal law the manufacturer must fix a safety defect at no cost to you — no charge for parts, labor or diagnosis — whether or not you are the original owner. A dealer cannot charge you for recall work, and cannot require you to have bought the vehicle from them.

That entitlement is not unlimited. It applies where the vehicle was first sold less than 15 years before the recall was announced — 5 years for tires. Past that a manufacturer may still do the repair free of charge, and many do, but they are no longer obliged to. This recall was reported on 3 May 1978.

To arrange the repair, contact any franchised dealer for the brand. If a dealer refuses the work or tries to charge for it, you can report that to NHTSA at nhtsa.gov/recalls or on 1-888-327-4236.

Official source

Recalling manufacturer
BUTLER MANUFACTURING
Recall initiated by
MFR

Everything on this page — the models listed, the build dates and the repair figures — comes from the manufacturer's filing to NHTSA and describes the vehicle line as a whole, not any individual car. Only the manufacturer can confirm whether a specific vehicle is affected, and whether its recall work has already been carried out. Check yours by VIN and read the official notice at nhtsa.gov/recalls.

Additional notes

Vehicle description: tank trailers.system: suspension; tandem axle, hanger bracket.consequences of defect: the correct tracking and functioning of the suspensionwould be affected and an accident could result without prior warning.note: the welds should immediately be inspected in the areas designated. If anycracks are found, the trailer should be withdrawn from service until thecracked welds can be repaired. Also, a slapping noise will occur duringbraking, signaling that there is a problem.

Check your own vehicle

This page describes the recall, not any one car. To see which recalls cover a specific vehicle, search by make, model and year.

A VIN lookup here identifies your vehicle and shows recalls issued for that make, model and year. It cannot tell you what is still open on your individual car - only the manufacturer knows that. Search by VIN instead, or check your VIN at nhtsa.gov for whether a recall is still open on your individual car.

Same component

Same brand