Audi Service Brakes, Hydraulic: Hoses, Lines/Piping, and Fittings

Audi is recalling about 414 vehicles over a problem with the service brakes, hydraulic. If the brake hose assembly separates, loss of braking power can occur increasing the potential for a vehicle accident.

Campaign
96E006000
Manufacturer
EIS BRAKE PARTS
Reported
4 March 1996
Vehicles
414
Built between
Jan 1987 – Dec 1995
Models
2
Recall type
Equipment
Initiated by
NHTSA investigation
Owners notified
10 April 1996
Repaired
Not reported
Unrepaired
Not reported

Does this affect my vehicle?

This recall covers vehicles built between January 1987 and December 1995. If yours was built outside that window, it is not part of this recall.

  • 1983-1986 Audi 5000Built January 1987 to December 1995
  • EIS SP6967Built January 1987 to December 1995

What the defect is

These brake hose assemblies have inadequate crimps attaching the hose to the hose fittings and could cause the hose and fitting to separate.

What could happen

If the brake hose assembly separates, loss of braking power can occur increasing the potential for a vehicle accident.

What gets fixed

THESE BRAKE HOSE ASSEMBLIES WILL BE REPLACED.

Timeline

  1. Vehicles builtJanuary 1987 to December 1995
  2. Recall reported to NHTSA4 March 1996
  3. Owners notified10 April 1996

Your rights

A safety recall repair is free. Under US federal law the manufacturer must fix a safety defect at no cost to you — no charge for parts, labor or diagnosis — whether or not you are the original owner. A dealer cannot charge you for recall work, and cannot require you to have bought the vehicle from them.

That entitlement is not unlimited. It applies where the vehicle was first sold less than 15 years before the recall was announced — 5 years for tires. Past that a manufacturer may still do the repair free of charge, and many do, but they are no longer obliged to. This recall was reported on 4 March 1996.

To arrange the repair, contact any franchised dealer for the brand. If a dealer refuses the work or tries to charge for it, you can report that to NHTSA at nhtsa.gov/recalls or on 1-888-327-4236.

Official source

Recalling manufacturer
EIS BRAKE PARTS
Recall initiated by
ODI

Everything on this page — the models listed, the build dates and the repair figures — comes from the manufacturer's filing to NHTSA and describes the vehicle line as a whole, not any individual car. Only the manufacturer can confirm whether a specific vehicle is affected, and whether its recall work has already been carried out. Check yours by VIN and read the official notice at nhtsa.gov/recalls.

Additional notes

System: brakes; hydraulic; lines; hoses.equipment description: aftermarket brake hose assemblies, model SP6957, for use on 1983 through 1986 audi 5000 vehicles.note: the vehicle owner should immediately return the vehicle to the service facility which performed the installation and the installer shold remove the brake hose assembly and replace it with assembly SP9037.EIS will remedy the defect without charge to the owner for the replacement of the defective parts and will pay the installing facility for its purchase cost of there placement part (a copy of the purchase invoice will be needed) plus a labor charge. Owners or installers can contact eis at 129 worthington ridge, berlin, connecticut 06037, attn. D. J. Duprey, quality assurance manager, or CALL1-203-828-8290. Also contact the national highway traffic safety administration's auto safety hotline at 1-800-424-9393.

Check your own vehicle

This page describes the recall, not any one car. To see which recalls cover a specific vehicle, search by make, model and year.

A VIN lookup here identifies your vehicle and shows recalls issued for that make, model and year. It cannot tell you what is still open on your individual car - only the manufacturer knows that. Search by VIN instead, or check your VIN at nhtsa.gov for whether a recall is still open on your individual car.

Same component

Same brand