chance

Chance Vs-24 Streetcar (1991) – 91V174000

Vehicle recall defect – Wiring Of The Tell-Tale Module, Located In The Rear Gate Unlock-Unlatch Mechanism, Causes The Rear Brakes To Be Applied And The Rear Gate To Unlatch When The Instrument Panel Push-To-Test Light Is Pressed.


Chance Vs24 (1983) – 87V148000

Vehicle recall defect – Weld Which Attaches The Support Bracket To The Rear Axle Of The Rear Suspension Could Crack And Break.


Chance Vs24 (1983) – 86V063000

Vehicle recall defect – Under Certain Conditions The Plastic Fan For The Under Floor Heater Could Catch On Fire Due To The Close Proximity To The Low Speed Resistor Which Generates Enough Heat To Ignite The Fan. Consequence Of Defect: Under Certain Conditions, This Could Result In A Fire In The Passenger Compartment.


Chance Vs24 (1982) – 87V148000

Vehicle recall defect – Weld Which Attaches The Support Bracket To The Rear Axle Of The Rear Suspension Could Crack And Break.


Chance Vs24 (1982) – 86V063000

Vehicle recall defect – Under Certain Conditions The Plastic Fan For The Under Floor Heater Could Catch On Fire Due To The Close Proximity To The Low Speed Resistor Which Generates Enough Heat To Ignite The Fan. Consequence Of Defect: Under Certain Conditions, This Could Result In A Fire In The Passenger Compartment.


Chance Vs24 (1981) – 87V148000

Vehicle recall defect – Weld Which Attaches The Support Bracket To The Rear Axle Of The Rear Suspension Could Crack And Break.


Chance Vs24 (1981) – 86V063000

Vehicle recall defect – Under Certain Conditions The Plastic Fan For The Under Floor Heater Could Catch On Fire Due To The Close Proximity To The Low Speed Resistor Which Generates Enough Heat To Ignite The Fan. Consequence Of Defect: Under Certain Conditions, This Could Result In A Fire In The Passenger Compartment.


Chance Vs24 (1980) – 87V148000

Vehicle recall defect – Weld Which Attaches The Support Bracket To The Rear Axle Of The Rear Suspension Could Crack And Break.


Chance Vs24 (1992) – 92V130000

Vehicle recall defect – The Jam-Nuts For The Right And Left Hand Tie Rods In The Drag Link Were Not Properly Torqued After Installation.