Vehicle recall defect – Vehicle Description: School Buses. These Buses Were Not Equipped With A Positive Hold Open Device (Retainer) For The Rear Emergency Door. This Does Not Meet The Requirements Of Fmvss No. 217, “Bus Window Retention And Release.”
Vehicle recall defect – Vehicle Description: School Buses. The Wall Side Attaching Bolts For Some Of The Passenger Seats May Have Been Installed Too Close To The Edge Of The Seat Ledge And In The Wrong Attaching Hole Resulting In Weakening Of The Seat Ledge At The Attachment Points.
Vehicle recall defect – Vehicle Description: Certain 10,000 Lb. Gvwr Non-School Buses With Chassis Fail To Comply With The Requirements Of Fmvss No. 225 “Child Restraint Anchorage Systems.” These Vehicles Were Manufactured Without An Upper Tether Anchorage As Required By The Standard.
Vehicle recall defect – Vehicle Description: School Buses. These Buses Were Not Equipped With A Positive Hold Open Device (Retainer) For The Rear Emergency Door. This Does Not Meet The Requirements Of Fmvss No. 217, “Bus Window Retention And Release.”
Vehicle recall defect – On Certain School And Transit Buses Equipped With Passenger Seat Belts With Retractors, The Cover Halves For The Retractable Portion Of The Belt Can Separate Completely And Release The Seat Belt Connector. If This Occurs, One Of The Load Bearing Pins In The Connector Could Separate From The Connector And Render The Seat Belt Unusable. In The Event Of A Crash, The Seat Occupant Would Not Be Properly Restrained Resulting In An Injury. The Seat Belt Supplier, Am-Safe, Will Provide A Snap On “Over-Cover” To Owners To Prevent The Seat Belt Cover From Separating.
Vehicle recall defect – Vehicle Description: School Buses. The Wall Side Attaching Bolts For Some Of The Passenger Seats May Have Been Installed Too Close To The Edge Of The Seat Ledge And In The Wrong Attaching Hole Resulting In Weakening Of The Seat Ledge At The Attachment Points.
Vehicle recall defect – Vehicle Description: Certain 10,000 Lb. Gvwr Non-School Buses With Chassis Fail To Comply With The Requirements Of Fmvss No. 225 “Child Restraint Anchorage Systems.” These Vehicles Were Manufactured Without An Upper Tether Anchorage As Required By The Standard.
Vehicle recall defect – Vehicle Description: School Buses. These Buses Were Not Equipped With A Positive Hold Open Device (Retainer) For The Rear Emergency Door. This Does Not Meet The Requirements Of Fmvss No. 217, “Bus Window Retention And Release.”
Vehicle recall defect – Vehicle Description: School Buses Equipped With 30-Inch And 34-Inch Seats And Barriers Or 36, 39, And 45-Inch Seats And Barriers With Offset Legs Installed In The First Body SeCTIon Behind The Driver. When Narrow Seats And Barriers (30″ And 34″) Or Seats And Barriers With Offset Legs Are Installed, Additional Floor Reinforcement Is Added. It Was Discovered This Reinforcement Interferes With And Chafes The Rubber Fuel Filler Hose.
Vehicle recall defect – Vehicle Description: School Buses. The Wall Side Attaching Bolts For Some Of The Passenger Seats May Have Been Installed Too Close To The Edge Of The Seat Ledge And In The Wrong Attaching Hole Resulting In Weakening Of The Seat Ledge At The Attachment Points.