Vehicle recall defect – The Flex Blade Fans On The Involved Vehicles May Develop Cracks In The Laminated Stiffener As A Result Of Fatigue During Operation. If Such A Condition Exists And The Cracks Go Undetected, Continued Operation Could Cause Pieces Of The Stiffener To Break Off.
Vehicle recall defect – In The Event Of Turbocharger Compressor Wheel Failure, One Or More Of The Four Capscrews That Hold The Turbocharger Together May Be Struck By Parts Of The Compressor Wheel, Resulting In The Capscrews Being Damaged. If These Capscrews Are Damaged To The Point That They Allow The Compressor Back Plate To Dislocate From The Turbocharger Bearing Housing, Engine Lubricating Oil May Be Allowed To Escape Under Pressure, ContActing The Engine Exhaust Manifold SeCTIons Or Turbocharger Turbine Housing.
Vehicle recall defect – A Short Circuit Could Occur Due To Chafing Or Wire DisconneCTIon In The Box.
Vehicle recall defect – Delays Of Up To About 2 Seconds May Exist In The Brake Application Times To The Brakes On The Bogie Axles In The Presence Of Certain Types Of Wheel Speed Sensor Signal Discontinuities Or Distortions That May Occur As A Result Of Sensor Wire Failure. This Constitutes A Non-Compliance To Federal Motor Vehicle Safety Standard No. 121, “Air Brake Systems”.
Vehicle recall defect – A Design Deficiency Exists In The Air Dryer Piping In The Area Of The Pressure Relief Valve And Compressor Governor Control Link. Moisture Is Passed And Builds Up In This Relief Valve And Control Line. In Freezing Ambient Temperatures, This Moisture May Freeze, Allowing The Chassis Air System Pressure To Exceed 150 Psi. Excessive Air System Pressure Can Cause Separation Of Air Piping ConneCTIons And Air System Valve Failure.
Vehicle recall defect – A Deficiency Exists In The Welds Securing The Rear Spring Insulator Bracket To The Axle Housing. This Is Due To Improper Positioning Of The Weld, In Relationship To The Bracket And Axle Housing. Failure Of The Welds Would Cause Separation Of The Spring Insulator Bracket And The Axle Housing, Resulting In Improper Alignment Of The Affected Axle.
Vehicle recall defect – The Flex Blade Fans On The Involved Vehicles May Develop Cracks In The Laminated Stiffener As A Result Of Fatigue During Operation. If Such A Condition Exists And The Cracks Go Undetected, Continued Operation Could Cause Pieces Of The Stiffener To Break Off.
Vehicle recall defect – The Spring Seat Plate, Located Between The Axle Housing And The Suspension Springs, May Deform Due To Spring Bending. As A Result, The ClaMPIng Force In The Assembly May Be Reduced. Loss Of ClaMPIng Force Could Cause Spring Failure And The Axle Will Dislocate. Also, The Tire Could Come Into Contact With The Spring.
Vehicle recall defect – The Flange Head Pinch Bolts Used In The Yokes Of The Steering Shaft Assemblies May Have Been Overstressed Due To The Bolts Not Being Tightened To Specifications. As A Result, The Pinch Bolts Could Break While In Service.