rx2

Vehicle recall defect – The Ground Wire From The Battery Ground On The Engine To The Frame Rail Was Omitted. This Constitutes A Non-Compliance To Federal Motor Vehicle Safety Standard No. 108, “Lamps, RefleCTIve Devices And Associated Equipment” And No. 121, “Air Brakes”. An Intermittent Loss Of Electrical Ground And Subsequent Dimming Of The Lighting System Components Or A Possible False Indication Of Anti-Lock System FunCTIon Is The Cause For The Non-Compliance.

Vehicle recall defect – The Involved Vehicles Do Not Conform To Federal Motor Vehicle Safety Standard No. 121, “Air Brake Systems”. These Vehicles Do Not Meet The 0.550 Second Brake Release Timing Requirement.

Vehicle recall defect – The Windshield Wiper May Over-Travel Its Designed Sweep Angle During Its Initial Stroke With The Possibility Of Temporary Wiper Immobilization.

Vehicle recall defect – Loss Of Lights And Engine Shutdown May Occur As A Result Of Electrical System Failure Due To Improper Circuit CriMPIng And Potential Heater Motor Circuit Overloading. Also, The Fuel Solenoid May Be Improperly Fused And The Headlight Harness Improperly Routed.

Vehicle recall defect – The Ground Wire From The Battery Ground On The Engine To The Frame Rail Was Omitted. This Constitutes A Non-Compliance To Federal Motor Vehicle Safety Standard No. 108, “Lamps, RefleCTIve Devices And Associated Equipment” And No. 121, “Air Brakes”. An Intermittent Loss Of Electrical Ground And Subsequent Dimming Of The Lighting System Components Or A Possible False Indication Of Anti-Lock System FunCTIon Is The Cause For The Non-Compliance.

Vehicle recall defect – The Involved Vehicles Do Not Conform To Federal Motor Vehicle Safety Standard No. 121, “Air Brake Systems”, In That Some Dual Compartment Air Reservoirs Were Installed Without A Drain Valve In Both Compartments. The Omission Of The Drain Valve Could Cause: 1) The Tank To Fill Up With Water Due To Condensation, 2) Reduced Air Volume, 3) Contamination Of The Air System With Water, Causing MalfunCTIon Of The Release Valves, Check Valves, Etc., And Increasing The Possibility Of Air System Component Freeze-Up In Cold Climates. These Conditions Could Result In Momentary Loss Of Braking Action.

Vehicle recall defect – The Vinyl Covered Interior Passenger Assist/Grab Handle Located On The Right Hand Hinge Pillar Can Wear And Fail In Service.

Vehicle recall defect – The Ground Wire From The Battery Ground On The Engine To The Frame Rail Was Omitted. This Constitutes A Non-Compliance To Federal Motor Vehicle Safety Standard No. 108, “Lamps, RefleCTIve Devices And Associated Equipment” And No. 121, “Air Brakes”. An Intermittent Loss Of Electrical Ground And Subsequent Dimming Of The Lighting System Components Or A Possible False Indication Of Anti-Lock System FunCTIon Is The Cause For The Non-Compliance.

Vehicle recall defect – The Involved Vehicles Do Not Conform To Federal Motor Vehicle Safety Standard No. 121, “Air Brake Systems”. These Vehicles Do Not Meet The 0.550 Second Brake Release Timing Requirement.

Vehicle recall defect – The Involved Vehicles May Fail To Comply With The Requirements Of Federal Motor Vehicle Safety Standard No. 121, “Air Brake Systems”. The Brakes May Fail To Release Within The Time Specified By The Standard.