Audi 5000 (1978) – 82V037000
Vehicle recall defect – On The Involved Vehicles, An Improperly Placed Mat Interferes With The Vibration Absorber Attached To The Underside Of The Accelerator. The Pedal May Not Fully Return To The Idle Position.
Vehicle recall defect – On The Involved Vehicles, An Improperly Placed Mat Interferes With The Vibration Absorber Attached To The Underside Of The Accelerator. The Pedal May Not Fully Return To The Idle Position.
Vehicle recall defect – The Fuel Pump May Stop FunCTIoning Without Warning. This Can Occur Because An Electrical Connector In The Fuse Panel May Overheat And Interrupt The Electrical Circuit.
Vehicle recall defect – On The Involved Vehicles, The Two Guide Bolts For Each Of The Left And Right Side Free-Floating Front Brake Calipers May Not Have Been Tightened According To Specifications During Assembly.
Vehicle recall defect – Steering Shaft Binder Bolts On Certain Vehicles Are Either Loose Or Over-Tightened. Either Condition Can Lead To A Separation Of The Steering Shaft From The Steering Column, Even If The Factory Installed Bolt Has Been Properly Retightened.
Vehicle recall defect – During High Speed Full Pressure Brake Applications, The Number Two Steering Axle May Self-Steer To A Partial Right Turn Without The Driver”S Control.
Vehicle recall defect – During High Speed Full Pressure Brake Applications, The Number Two Steering Axle May Self-Steer To A Partial Right Turn Without The Driver”S Control.
Vehicle recall defect – The Bypass Oil Filter Mounting Brackets May Be Insufficiently Welded To The Radiator Frame. This Could Allow The Filter Mounting Bracket And Oil Filter To Come Loose, Fall, And Wedge Themselves Within The Steering Geometry.
Vehicle recall defect – Some Of The Involved Vehicles Were Not Inspected For Adequate Clearance Between The Steering Shaft And Its Firewall Opening. Inadequate Clearance Could Result In The Steering Column Becoming Scored Or Severed By The Firewall Sheet Metal.
Vehicle recall defect – Lockwashers, Used To Retain The Engine”S Fan Mounting Bolts, May Have Been Omitted During Assembly, Causing The Bolts To Loosen And Allowing The Fan To Separate From Its Mounting Hub.
Vehicle recall defect – The Hose Clamp, Which Was Installed Around The Steering Column Boot Seat To Keep Noise And Dirt From Entering The Cab, May Loosen.