Dodge Steering: Shaft Pitman

Dodge is recalling about 1,500 vehicles over a problem with the steering. Steering loss could result in a vehicle crash possibly resulting in property damage, injury or death.

Campaign
10E013000
Manufacturer
FABTECH MOTORSPORTS
Reported
3 May 2010
Vehicles
1,500
Built between
Not published
Models
5
Recall type
Equipment
Initiated by
Manufacturer
Owners notified
24 May 2010
Repaired
Not reported
Unrepaired
Not reported

Does this affect my vehicle?

The manufacturer did not publish a build-date range for this recall, so the model and year list below is the only way to tell whether your vehicle is covered.

  • 2003-2008 Dodge RAM 1500
  • 2003-2008 Dodge RAM 2500
  • 2003-2008 Dodge RAM 3500
  • Fabtech FT44039
  • Fabtech FTS93001

What the defect is

Fabtech is recalling certain aftermarket replacement pitman arms, p/nos. FTS93001 and FT44039, installed for use on certain 2003 through 2008 dodge 2500 4WD, 3500 4WD, and 1500 4WD mega cab vehicles. The pitman arm can fracture and break away from the steering box causing total loss of steering control.

What could happen

Steering loss could result in a vehicle crash possibly resulting in property damage, injury or death.

What gets fixed

FABTECH WILL NOTIFY OWNERS AND AUTHORIZED INSTALLERS WILL INSPECT FOR DEFECTIVE PITMAN ARM AND REPLACE IF NECESSARY FREE OF CHARGE. THE SAFETY RECALL BEGAN ON MAY 24, 2010.

Timeline

  1. Recall reported to NHTSA3 May 2010
  2. Owners notified24 May 2010

Your rights

A safety recall repair is free. Under US federal law the manufacturer must fix a safety defect at no cost to you — no charge for parts, labor or diagnosis — whether or not you are the original owner. A dealer cannot charge you for recall work, and cannot require you to have bought the vehicle from them.

That entitlement is not unlimited. It applies where the vehicle was first sold less than 15 years before the recall was announced — 5 years for tires. Past that a manufacturer may still do the repair free of charge, and many do, but they are no longer obliged to. This recall was reported on 3 May 2010.

To arrange the repair, contact any franchised dealer for the brand. If a dealer refuses the work or tries to charge for it, you can report that to NHTSA at nhtsa.gov/recalls or on 1-888-327-4236.

Manufacturer contact

Owners may contact fabtech at 1-877-432-2832.

Official source

Recalling manufacturer
FABTECH MOTORSPORTS
Recall initiated by
MFR

Everything on this page — the models listed, the build dates and the repair figures — comes from the manufacturer's filing to NHTSA and describes the vehicle line as a whole, not any individual car. Only the manufacturer can confirm whether a specific vehicle is affected, and whether its recall work has already been carried out. Check yours by VIN and read the official notice at nhtsa.gov/recalls.

Additional notes

This recall only pertains to aftermarket fabtech replacement pitman arms and has no relation to any original equipment installed on dodge 2500, 3500, and 1500 vehicles manufactured by chrysler group, llc.owners may also contact the national highway traffic safety administration's vehicle safety hotline at 1-888-327-4236 (tty 1-800-424-9153), or go to <a href=http://www.safercar.gov>http://www.safercar.gov</a> .

Check your own vehicle

This page describes the recall, not any one car. To see which recalls cover a specific vehicle, search by make, model and year.

A VIN lookup here identifies your vehicle and shows recalls issued for that make, model and year. It cannot tell you what is still open on your individual car - only the manufacturer knows that. Search by VIN instead, or check your VIN at nhtsa.gov for whether a recall is still open on your individual car.

Same component

Same brand