Vehicle recall defect – Vehicle Description: Heavy Duty Trucks Equipped With Air Brake Haldex Automatic Slack Adjusters, Long Stroke Brake Chambers, And Dana Brakes. The Automatic Slack Adjuster Anchor Brackets Can Fail Due To Fatigue Fracture And Completely Separate, Causing The Slack Adjusters To FunCTIon As Manual Slack Adjusters.
Vehicle recall defect – Vehicle Description: Heavy Duty Trucks Built With International Code 16Sch (Lower Bunk Webbing Restraint). Incorrect Bolts Were Used To Hold The Bunk Webbing Restraint Latch Brackets To The Bunk Base.
Vehicle recall defect – The Drive Axle Housings Consist Of A Plate Steel Center SeCTIon And Two Forged Spindles, One Of Which Is Welded To Each End Of The Center SeCTIon. Each Spindle Contains A Keyway Slot In Which The Locking Tab For The Wheel Bearing Nut Locking Mechanism Is Inserted. The Length Of The Keyway Slot May Not Be Long Enough To Accommodate The Tab Causing The Tab To Be Deformed Or Damaged During Installation.
Vehicle recall defect – These Vehicles Are Equipped With A Detroit Diesel Optimized Idle System. If The Ignition Is Turned On And The Fuse For The Electronic Control Module (Ecm) Power Feed Line Is Removed Or Burned Out, Unintentional Cranking Of The Engine Will Occur..
Vehicle recall defect – Vehicle Description: Heavy Duty Trucks Equipped With Six-Spoke Wheel Assemblies. These Vehicles Were Manufactured With The Wrong Combinations Of Wheel Assembly Parts. Should The Six-Spoke Wheel Assembly Have Mis-Matched Parts, High Stresses In The Wheel Studs And Potential Wheel Failures Can Occur.
Vehicle recall defect – Vehicle Description: Trucks Assembled With Skf Level 2 Truck Hub Units (Thu) Received From Meritor. These Hubs Can Fatigue Crack.
Vehicle recall defect – Vehicle Description: Heavy Duty Trucks Equipped With Six-Spoke Wheel Assemblies. These Vehicles Were Manufactured With The Wrong Combinations Of Wheel Assembly Parts. Should The Six-Spoke Wheel Assembly Have Mis-Matched Parts, High Stresses In The Wheel Studs And Potential Wheel Failures Can Occur.
Vehicle recall defect – Vehicle Description: Heavy Duty Trucks Equipped With Dana/Sprague Windshield Wiper Assemblies. The Knurled Pivot Shaft (Which Operates The Windshield Wiper Arm) Is Welded To A Lever, Which Connects To Linkage From The Wiper Motor. The Weld At The Pivot Shaft To Lever Can Fail.
Vehicle recall defect – Vehicle Description: Class 8 Heavy Duty Truck Chassis Equipped With 16,000 Lb., 18,000 Lb., Or 20,000 Lb. Heavy Duty Steering Axles. The Inner Wheel Bearing Cone For The Steering Axle Wheel Hub Assembly Does Not Properly Fit Onto The Navistar Steering Axle Spindle Assembly. Improper Fit Of The Bearing To The Spindle Increases The Stress Levels To The Steering Axle Spindle Which Could Cause Spindle Failure.
Vehicle recall defect – Vehicle Description: Heavy Duty Trucks Equipped With Spicer Spl170 55Mm Center Bering Package. The End Yoke Retaining Nut Can Loosen.