Vehicle recall defect – Dana Incorporated (Dana) Is Recalling Certain Heavy Vehicle Output Shafts, Part Number 131536, Used In Drive Axles Manufactured For Commercial Vehicles. The Output Shafts May Not Have Been Properly Heat Treated, Which Can Cause The Shaft To Fracture At The Transition Of The Shaft Splines To The Thread, Allowing The Shaft Or The Interaxle Driveline To Detach From The Vehicle.
Vehicle recall defect – Hose Layer Separation Occurred At Applied Test Load Below MinimUM Required Load.
Vehicle recall defect – The Upper Ball Joint Casings All Outside The Certified Design Hardness.
Vehicle recall defect – Cylinder Rod And Rod Joints Are Welded, These Welds Are Subject To Brittle Fatigue Fracture Caused By Rapid Cooling Also The Weld Area Is Contaminated By Chrome Plating.
Vehicle recall defect – Due To A Change In The Original Equipment Manufacturers Center SeCTIon Of The Idler Arm, The Castellated Nut Which Holds The Idler Arm Could Not Be Tightened Enough To Insert A Cotter Pin. Consequence Of Defect: Omission Of The Cotter Pin Could Allow The Castellated Nut To Back Off. Without The Nut The Idler Arm/Center Link ConneCTIon Would Be Lost, Resulting In A Loss Of Steering.