Vehicle recall defect – Vehicle Description: School And Transit Buses. Some Certification Labels Displayed The Incorrect Tire Pressure For The Tire Specified To Meet The Gross Axle Weight Rating For The Front And/Or Rear Axles. This Does Not Meet The Certain Requirements Of Fmvss No. 120, “Tire SeleCTIon And Rims For Motor Vehicles Other Than Passenger Cars,” And 49 Cfr Part 567, “Certification.”
Vehicle recall defect – Vehicle Description: Certain School And Transit Buses Were Built With A Poor Quality Heater/Defroster Blower Switch. In Some Cases This Has Caused The Melting Of The Heater Harness Connector At The Switch Terminals Or The High-Speed Wire Insulation At The Connector. Also, Some Of The Units Had Improper Circuit ProteCTIon Size Installed In The Heater Defroster Circuit.
Vehicle recall defect – Ce Model School Buses Which Fail To Comply To Federal Motor Vehicle Safety Standard No. 221, School Bus Body Joint Strength. The Roof Top Sheet May Be Improperly Located, Reducing The Material Edge Distance At The Rivet Line.
Vehicle recall defect – Vehicle Description: School And Transit Buses. Some Certification Labels Displayed The Incorrect Tire Pressure For The Tire Specified To Meet The Gross Axle Weight Rating For The Front And/Or Rear Axles. This Does Not Meet The Certain Requirements Of Fmvss No. 120, “Tire SeleCTIon And Rims For Motor Vehicles Other Than Passenger Cars,” And 49 Cfr Part 567, “Certification.”
Vehicle recall defect – Vehicle Description: School And Transit Buses. Some Certification Labels Displayed The Incorrect Tire Pressure For The Tire Specified To Meet The Gross Axle Weight Rating For The Front And/Or Rear Axles. This Does Not Meet The Certain Requirements Of Fmvss No. 120, “Tire SeleCTIon And Rims For Motor Vehicles Other Than Passenger Cars,” And 49 Cfr Part 567, “Certification.”
Vehicle recall defect – Vehicle Description: School Buses Built With Bendix Air Abs With An Ec-17 1030R Electronic Control Unit (Ecu). There Have Been Reports Of Unwanted Abs Activation At Low Speeds Caused By 1) Chafed Abs Wheel Speed Sensor Wires On Rotating Parts Or 2) A Damaged Component At The Wheel End That Generates A Certain Type Of Erratic Sensor Signal.
Vehicle recall defect – Vehicle Description: School Buses Equipped With Flip Seats At The Emergency Exits. The Seat Cushion Hinge On The Combination Flip Seat Is Located In Such A Manner That It Is Within Easy Reach Of The Passenger Sitting In The Seat Located Behind The Combo Flip Seat.
Vehicle recall defect – Vehicle Description: School Buses. The Emergency Door Hinges That Consist Of Steel Pin Fittings And/Or Lacklubrication Can Bind From Rust And/Or Corrosion.
Vehicle recall defect – The Low Pressure Power Steering Return Hose Can Either Burst Or Become Disconnected Due To Increased Fluid Viscosity In Frigid Temperatures.
Vehicle recall defect – Ce Model School Buses Which Fail To Comply To Federal Motor Vehicle Safety Standard No. 221, School Bus Body Joint Strength. The Roof Top Sheet May Be Improperly Located, Reducing The Material Edge Distance At The Rivet Line.